H3C Technologies H3C S12500 Series Switches - Manual (Page 31)

24
# Display ENDC information.
[SwitchA] display evi neighbor-discovery client summary
Status: I-Init E-Establish P-Probe
Interface Local Address Server Address Network ID Auth Status
Tunnel0 1.1.1.1 1.1.1.1 1 disabled E
# Display EVI neighbors registered with the ENDS.
[SwitchA] display evi neighbor-discovery server member
Interface: Tunnel0 Network ID: 1
IP Address: 1.1.1.1
Client Address System ID Expire Created Time
1.1.1.1 000F-0001-0001 25 2012/01/01 00:00:43
1.1.2.1 000F-0001-0002 15 2012/01/01 01:00:46
1.1.3.1 000F-0001-0003 20 2012/01/01 01:02:13
# Display neighbor entries that Switch A has learned.
[SwitchA] display evi neighbor-discovery client member
Interface: Tunnel0 Network ID: 1
Local Address: 1.1.1.1
Server Address: 1.1.1.1
Neighbor System ID Created Time Expire Status
1.1.2.1 000F-0001-0002 2012/01/01 12:12:12 13 Up
1.1.3.1 000F-0001-0003 2012/01/01 12:12:12 12 Up
2. Verify the configuration on Switch B:
# Display information about the EVI tunnel interface.
[SwitchB] display interface tunnel 0
Tunnel0
Current state: UP
Line protocol state: UP
Description: Tunnel0 Interface
Maximum Transmit Unit: 64000
Internet protocol processing: disabled
Tunnel source 1.1.2.1
Tunnel keepalive enabled, Period(20 s), Retries(2)
Network ID 1
Tunnel protocol/transport GRE_EVI/IP
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Display information about EVI-Link interfaces.
[SwitchB] display evi link interface tunnel 0
Interface Status Source Destination
Evi-Link1 UP 1.1.2.1 1.1.1.1
Evi-Link2 UP 1.1.2.1 1.1.3.1
# Display ENDC information.
[SwitchB] display evi neighbor-discovery client summary
Status: I-Init E-Establish P-Probe