Verifying the configuration, Evi layer 2 multicast configuration example, Displaying and maintaining evi – H3C Technologies H3C S12500 Series Switches User Manual
Page 35
28
3.
Configure all the other sites in the same way that site 1 is configured. Make sure extended VLANs
are correctly configured at each site.
Verifying the configuration
# Display neighbors registered with the ENDS in each EVI network.
[Site4] display evi neighbor-discovery server member
Interface: Tunnel101 Network ID: 1
IP Address: 172.16.4.1
Client Address System ID Expire Created Time
172.16.2.1 000F-0001-0002 25 2011/01/01 00:00:43
172.16.3.1 000F-0001-0003 15 2011/01/01 01:00:46
172.16.4.1 000F-0001-0004 20 2011/01/01 01:02:13
Interface: Tunnel102 Network ID: 2
IP Address: 172.16.4.1
Client Address System ID Expire Created Time
172.16.1.1 000F-0001-0001 19 2011/01/01 00:19:31
172.16.2.1 000F-0001-0002 25 2011/01/01 00:00:43
172.16.3.1 000F-0001-0003 15 2011/01/01 01:00:46
172.16.4.1 000F-0001-0004 20 2011/01/01 01:02:13
172.16.5.1 000F-0001-0005 18 2011/01/01 01:04:32
Interface: Tunnel103 Network ID: 3
IP Address: 172.16.4.1
Client Address System ID Expire Created Time
172.16.1.1 000F-0001-0001 19 2011/01/01 00:19:31
172.16.4.1 000F-0001-0004 20 2011/01/01 01:02:13
EVI Layer 2 multicast configuration example
Configure the EVI network (network ID 1) in
to transmit multicast traffic for the multicast group
at 228.8.8.8 in VLAN 100. The multicast source is connected to Switch A in Site 1, and a receiver host
is attached to Switch B in Site 2.
In the EVI network, Switch A is the ENDS, and Switch B is the ENDC.