H3C Technologies H3C S10500 Series Switches - Manual (Page 186)

175
[PE1-vsi-bbb] pwsignal bgp
[PE1-vsi-bbb-bgp] route-distinguisher 100:1
[PE1-vsi-bbb-bgp] vpn-target 111:1
[PE1-vsi-bbb-bgp] site 10
[PE1-vsi-bbb-bgp] quit
[PE1-vsi-bbb] quit
# On the interface connecting CE 1, create service instance 1000 and bind it with VPLS instance aaa,
and create service instance 2000 and bind it with VPLS instance bbb.
[PE1] interface gigabitethernet 1/0/1
[PE1-GigabitEthernet1/0/1] service-instance 1000
[PE1-GigabitEthernet1/0/1-srv1000] encapsulation s-vid 100
[PE1-GigabitEthernet1/0/1-srv1000] xconnect vsi aaa
[PE1-GigabitEthernet1/0/1-srv1000] quit
[PE1-GigabitEthernet1/0/1] service-instance 2000
[PE1-GigabitEthernet1/0/1-srv2000] encapsulation s-vid 200
[PE1-GigabitEthernet1/0/1-srv2000] xconnect vsi bbb
[PE1-GigabitEthernet1/0/1-srv2000] quit
[PE1-GigabitEthernet1/0/1] quit
2. Configure the P device.
<Sysname> system-view
[Sysname] sysname P
[P] interface loopback 0
[P-LoopBack0] ip address 2.2.2.9 32
[P-LoopBack0] quit
# Configure the LSR ID and enable MPLS globally.
[P] mpls lsr-id 2.2.2.9
[P] mpls
[P-mpls] quit
# Enable LDP globally.
[P] mpls ldp
[P-mpls-ldp] quit
# Configure the interface connected with PE 1 and enable LDP on the interface.
[P] interface vlan-interface 2
[P-Vlan-interface2] ip address 23.1.1.2 24
[P-Vlan-interface2] mpls
[P-Vlan-interface2] mpls ldp
[P-Vlan-interface2] quit
# Configure the interface connected with PE 2 and enable LDP on the interface.
[P] interface vlan-interface 3
[P-Vlan-interface3] ip address 26.2.2.2 24
[P-Vlan-interface3] mpls
[P-Vlan-interface3] mpls ldp
[P-Vlan-interface3] quit
# Configure OSPF.
[P] ospf
[P-ospf-1] area 0