H3C Technologies H3C S10500 Series Switches - Manual (Page 311)

300
Configuring inter-AS option C
Network requirements
• Site 1 and Site 2 belong to the same VPN. Site 1 accesses the network through PE 1 in AS 100 and
Site 2 accesses the network through PE 2 in AS 600.
• PEs in the same AS run IS-IS.
• PE 1 and ASBR-PE 1 exchange labeled IPv4 routes by MP-iBGP.
• PE 2 and ASBR-PE 2 exchange labeled IPv4 routes by MP-iBGP.
• PE 1 and PE 2 are MP-eBGP peers.
• ASBR-PE 1 and ASBR-PE 2 use their respective routing policies and label the routes received from
each other.
• ASBR-PE 1 and ASBR-PE 2 use MP-eBGP to exchange labeled IPv4 routes.
Figure 76 Configure inter-AS option C
Device Interface IP address Device Interface IP address
PE 1 Loop0 2.2.2.9/32 PE 2 Loop0 5.5.5.9/32
Loop1 30.0.0.1/32 Loop1 20.0.0.1/32
Vlan-int11 1.1.1.2/8 Vlan-int11 9.1.1.2/8
ASBR-PE 1 Loop0 3.3.3.9/32 ASBR-PE 2 Loop0 4.4.4.9/32
Vlan-int11 1.1.1.1/8 Vlan-int11 9.1.1.1/8
Vlan-int12 11.0.0.2/8 Vlan-int12 11.0.0.1/8
Configuration procedure
1. Configure PE 1
# Run IS-IS on PE 1.
<PE1> system-view
[PE1] isis 1
[PE1-isis-1] network-entity 10.1111.1111.1111.1111.00
[PE1-isis-1] quit
# Configure LSR ID, enable MPLS and LDP.
[PE1] mpls lsr-id 2.2.2.9
[PE1] mpls
[PE1-mpls] label advertise non-null