H3C Technologies H3C SR8800 User Manual
High availability configuration guide
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Title Page
- Preface
- Contents
- High availability overview
- Configuring active and standby switchover
- Configuring Ethernet OAM
- Configuring RPR
- RPR overview
- RPR configuration task list
- Configuring basic RPR functions
- Configuring RPR protection
- Configuring the ringlet selection table
- Configure the RPR fairness algorithm
- Configuring RPR timers
- Testing connectivity between RPR stations
- Displaying and maintaining RPR
- RPR configuration examples
- Configuring VRRP
- VRRP overview
- VRRP standard protocol mode
- VRRP load balancing mode
- Configuring VRRP for IPv4
- VRRP for IPv4 configuration task list
- Configuring a VRRP working mode
- Specifying the type of MAC addresses mapped to virtual IP addresses
- Specifying the VRRP control VLAN
- Creating a VRRP group and configuring virtual IP address
- Configuring router priority, preemptive mode and tracking function
- Configuring VF tracking
- Configuring VRRP packet attributes
- Enabling the trap function for VRRP
- Displaying and maintaining VRRP for IPv4
- Configuring VRRP for IPv6
- VRRP for IPv6 configuration task list
- Specifying the type of MAC addresses mapped to virtual IPv6 addresses
- Creating a VRRP group and configuring a virtual IPv6 address
- Configuring router priority, preemptive mode and tracking function
- Configuring VF tracking
- Configuring VRRP packet attributes
- Displaying and maintaining VRRP for IPv6
- IPv4-based VRRP configuration examples
- IPv6-based VRRP configuration examples
- Troubleshooting VRRP
- Configuring BFD
- Configuring track
- Track overview
- Track configuration task list
- Associating the track module with a detection module
- Associating the track module with an application module
- Displaying and maintaining track entries
- Track configuration examples
- VRRP-track-NQA collaboration configuration example (the master monitors the uplinks)
- Configuring BFD for a vrrp backup to monitor the master
- Configuring BFD for the VRRP master to monitor the uplink
- Static routing-track-NQA collaboration configuration example
- Static routing-track-BFD collaboration configuration example
- VRRP-track-interface management collaboration configuration example (the master monitors the uplink interface)
- Index