Grass Valley 8960DEC - Manual (Page 16)

16 8960DEC—Instruction Manual
Power Up
Power Up
The front LED indicators and configuration switches are illustrated in
Figure 6 . Upon power-up, the green PWR LED should light and the yellow
CONF LED should illuminate for the duration of module initialization.
Note When a media module is first plugged into a Gecko or GeckoFlex frame, the
8900NET module (if present) may report a momentary fault. This will clear
once the media module has booted up.
Operation Indicator LEDs
With factory default configuration and a valid input signal connected, the
green PWR LED and one of the green signal standard LEDs (525 or 625)
should illuminate (refer to
Table 2 on page 17 to see the possible operating
indicator combinations).
Video input presence is indicated by the 525 or 625 LED (indicating a
525-line or 625-line input signal has been detected). Line standard must be
set manually, there is no auto detection.
Figure 6. LEDs and Configuration Switches
0642_06
r1
0
1
2
3
4 5 6
7
8
9
A
B C D
16-position
Rotary switch
Momentary toggle switch
525 – Green LED on indicates 525-line input is present
PWR – Green LED on indicates power OK
FAULT – Red LED is off during normal operation
Ejector Tab
COMM – Yellow LED indicates communication activity
CONF – Yellow LED indicates configuration activity
Auto/Manual MODE – Yellow LED on indicates automatic input detection mode
625 – Green LED on indicates 625-line input is present
Filter – Yellow LED on indicates signal is being cross-color filtered
Module Configuration Switches and LED
GND
2nd Function
(yellow)