8960dec module onboard configuration settings, Table 5 – Grass Valley 8960DEC User Manual
Page 24
24
8960DEC—Instruction Manual
Configuration
8960DEC Module Onboard Configuration Settings
To make a configuration setting:
1.
Rotate the Function switch to the First Bank (2ND LED off) or Second
Bank (2ND LED on) and to the desired function within that bank.
2.
Move the paddle switch to the up or down position and hold
momentarily to set the desired function. Refer to
for specific
paddle switch settings.
Refer to the Configuration Summary in
for a
summary of what video lines are affected by each control, all parame-
ters, step sizes, default values, etc.
Table 5. Decoder Configuration Functions
Function
Switch
Paddle
Switch Up
Paddle
Switch Down
Function Description
First Bank - 2ND
LED
Off
Input Signal Adjustments
0
–
–
Not used
1
525
625
Select input video Line Standard selection.
2
Setup No
Setup
(525 only) Select Setup if setup is present in the input video, No
Setup if setup is not present.
3
NTSC PAL-M
1
(525 only) Select NTSC or PAL-M subcarrier format.
4
Increase
Decrease
Adjust Input Video Gain (% relative to 1 V p-p).
Signal Processing Adjustments
5
User
Calibrate
Set to User to enable processing amplifier functions (6-9) or
Calibrate for presets optimized for calibrated video input.
6
Increase
Decrease
Adjust Luma Gain (% relative to white).
7
Increase
Decrease
Adjust Black Level (% relative to white).
8
Increase
Decrease
Adjust Chroma Gain (% relative to 100% saturation).
9
+
–
(525 only) Rotate Hue ± 180 degrees.
Signal Filtering Setup
A
High
Low
Set adaptive decoding sensitivity
B
Inactive Position - return here when finished with configuration
C
Notch
Decode
Delete
Select Notch Decode to process and pass VBI content (set filter
type with D below,) or Delete to remove content (lines 10-20
NTSC, lines 6-25 PAL-B) and apply no filtering.
D
Notch
Decode
Video to Luma
Select filter type when Notch Decode is selected above,
E
Enable
Disable
Enable or Disable Ramp Test Signal output.
F
No function
Recall Defaults
Recall Factory Default. Refer to
for defaults.