Grass Valley FXE-1501 - Manual (Page 7)

GUIDE TO INSTALLATION AND OPERATION
FXE-1501 | 3
2 Installation
2.1 Unpacking
Make sure the following items have been shipped with your FXE-1501. If any of the following items are missing,
contact your distributor or Miranda Technologies Inc.
• FXE-1501 Fiber Ethernet Transceiver
• FXE-1501-SRP Rear Panel (see figure 2.1)
2.2 Installation in the Densité frame
The FXE-1501 and its associated rear connector rear panel are designed for installation in a Densité 2 frame. It is not
necessary to switch off the frame’s power when installing or removing the card.
• With the use of available adapters, this card and its associated rear panel can be installed in a Densité 3 frame.
See the Densité 3 frame manual for details.
2.3 Rear Connector Panel
The FXE-1501-SRP single-slot rear panel, mounted in a Densité 2 or Densité 3 frame, incorporates these connectors:
• One socket for inserting a fiber transmitter/receiver SFP module
• One RJ-45 for connection to the ethernet
It also incorporates status indicators for:
Ethernet Activity:
integrated into the RJ45 plug
Ethernet GigE:
integrated into the RJ45 plug
Fiber Link Activity: beside the optical SFP socket
Figure 2.1 FXE-1501-SRP Rear Panel