Grass Valley K2 Dyno PA v.1.5 - Manual (Page 45)

• Use Dyno Marks for Transfer/Export: If you check this box, Dyno PA uses
Mark In and Mark Out points that were automatically added to the asset by a
K2 Dyno Replay Controller.
• Single Transfer Queue: If you check this box, transfers are initiated (pulled)
from the K2 Summit system that is the destination server. If the box is
unchecked, transfers are initialed (pushed) from the source, which means they
might be affected by queue limitations.
8. Click OK .
The rule appears in the Rules pane.
9. When created, a rule is inactive. To activate a rule, right-click on the rule and select
Toggle Activate .
A message box displays listing the number of transfers that will take place once
this rule has been activated.
10. To begin transferring these transfers immediately, click Yes .
Once a rule has been activated, a play symbol displays next to the rule. Inactive
rules have a stop symbol. To monitor the transfer, open the Active Transfers
pane.
NOTE: If the rule is reset, or there was an error in the transfer, the transfer
in the Active Transfer pane must be deleted before Dyno PA will retry the
transfer.
Editing a rule
1. In the Rules pane, right-click the rule you want to edit and select Edit .
2. If changing one of the rule criteria, highlight the criterion and click the Edit or the
Delete button.
3. Make the desired changes.
4. To accept the changes, click OK .
An edited rule is automatically reset to inactive.
5. To activate the rule again, highlight it and select Toggle Activate .
15 October 2010 Dyno Production Assistant User Manual 45
Transferring Assets with K2 Dyno PA