Grass Valley K2 System Guide v.7.2 - Manual (Page 245)

07 April 2010 K2 System Guide 245
Making Rack Slide Adjustments
2. Push the chassis toward the rack until the chassis sections meet the locking bracket.
3. Verify the cabinet is pushed fully into the rack.
4. Insert and tighten the front panel retaining screws as shown in the previous
diagram.
Making Rack Slide Adjustments
After installation, binding may occur if the slide tracks are not properly adjusted. To
adjust the tracks:
1. Slide the chassis out approximately 10 inches.
2. Slightly loosen the mounting screws holding the tracks to the front of the rails and
allow the tracks to seek an unbound position.
3. Tighten the mounting screws and check the tracks for smooth operation by sliding
the chassis in and out of the rack several times.
4. Tighten the front panel retaining screws once the cabinet is in place within the rack
to complete the installation.