Grass Valley 1200 Installation - Manual (Page 131)

4-17
System Restart after Power-Serge
System Restart after Power-Serge
If you should suffer a power serge, follow these steps to restart your
system:
1. With the Model 1200 signal processor frame and control panel powered
up, press MISC menu button.
2. The screen displays the MISC MENU . Select CLEAR DP RAM .
3. The system asks whether to CONFIRM or CANCEL . Select CONFIRM .
4. The Model 1200 frame begins clearing the frame Dual Ported RAM, and
for approximately 10 seconds, the screen displays CLEAR DPRAM is in
progress...
The screen then displays DPRAM has been cleared. Wait 5 seconds for
the frame to transmit the new Switcher configuration to the 1200
control panel.
MISC MENU
OFF
LAMP SAV
ENABLE
SHUT
DOWN
ON
– Warning –
CONFIRM CANCEL
SHUT DOWN will halt the frame
and require turning the frame
power OFF then ON or pressing the
frame reset button
Exit
LAMPSAVER DELAY
= 20 MINUTES
FACTORY
RESET
CLEAR
DP RAM
CLEAR
WRK BUF