Grass Valley 1200 Installation - Manual (Page 30)

2-2
Section 2 Ñ Installation
Unpacking
The Model 1200 is packaged in several boxes:
■ One containing the Signal Processor Frame
■
One containing the Control Panel
■ One containing the panel cable, power cord, pushbutton lens chips,
keyboard adaptor cable, and instruction manuals
Check the contents of each box against the packing slip to ensure that you
received everything that you ordered. If anything is missing or damaged,
contact your supplier immediately.
Information Required Before Installation
Required Tools and Supplies
The following tools and supplies are required but not supplied:
■
A standard PC/AT keyboard or a keyboard acquired from Grass
Valley (Marquardt Mini Board Keyboard #EA2452). The keyboard
requires an adaptor (CA4216) which is included with the Model 1200.
■
Assorted Screwdrivers: Flat-blade, Phillips, and T10 TORX (optional)
■
Nutdriver and assorted sockets
■ Drill and 5/32Ó or 4 mm bit for drilling holes to mount the panel
■
Ten #6 screws, nuts, and washers for securing the panel to the desk
■ Four #6-32 machine screws, nuts, and washers for securing the rear
mounting brackets to the panel
■ Four #6 screws, nuts, and washers for securing the rear mounting
brackets to the desk
■ Four suitable screws and nylon washers for securing the frame in the
rack
■
A mechanical lifting device or two or more people to lift the frame
■
Video cables: serial 75 ohm BNC cables and parallel component digital
video cables with male 25-pin D connectors
■
Connectors and wiring: Male 25-pin D connectors, male 9-pin D
connectors, plus wire and sheathing for assembling data cables