Grass Valley PRS 250 RAID Storage System - Manual (Page 33)

Configurations and Cabling
RAID Instructions 2-15
Two-Channel Profile/X Single-SP RAIDs
This configuration, see the following illustration, consists of a two-channel Profile
disk recorder (one MDR) connected to multiple RAID chassis, daisy-chained
together.
1. Connect a SCSI-2 cable from the Profile MDR rear panel connector to the first
RAID chassis SCSI A IN connector.
2. Connect a second SCSI-2 cable from the first RAID chassis SCSI A OUT
connector to the second RAID chassis SCSI A IN connector.
3. Connect a third SCSI-2 cable from the second RAID chassis SCSI A OUT
connector to the third SCSI A IN connector.
4. Repeat Steps 2 and 3 for the remaining number of RAIDs. See page 2-13 to
determine the maximum number of RAIDs that can be connected to your Profile
disk recorder.
5. Connect a SCSI terminator to the SCSI A OUT connector of the last RAID chassis
in the chain.
0226-2
J10
SCSI-2 Terminator
SCSI-2 Cable
RAID Chassis
2-Channel Profile Disk Recorder