Grass Valley PRS 250 RAID Storage System - Manual (Page 39)

Connecting the Power Cord
RAID Instructions 2-21
Connecting the Power Cord
1. Make sure that the storage chassis power switch is off, then connect the power cord
to the storage chassis.
NOTE: Several types of power cord are supplied with the product. Use the power
cord that is appropriate to your installation.
2. Plug the other end of the power cord into an ac power outlet.
Plugging in the ac power cord
You are ready to power up the storage chassis as described in the following section,
Powering Up the Storage Chassis.
Back of storage
A. Push power switch
to off (0) position. B. Plug power cord into
power connector.