Grass Valley PRS 250 RAID Storage System - Manual (Page 86)

IDX-2 RAID Instructions
status lights
busy 1-5
fault 1-5
Disk modulesLicensed Internal Code location
3-11
E
Emergency Procedures (without an ESD kit)
3-16
ENA, Disk module status code, Presentation
Utility screen 3-4
ESD
avoiding damage 3-15
procedure 3-15
Europe, Tektronix Product Support i
F
Fan Module 1-7
indicator 1-7
replacing 3-32
Fault light
disk module 1-5
Field Replaceable Units B-2
FMT, Disk module status code, Presentation
Utility screen 3-4
H
Handling CRUs 3-15
Heartbeat status indicator for SP 3-2
Height
storage system A-2
I
Indicators
Disk Drive Module 1-5
Fan Module 1-7
SP 1-4
VSC 1-6
Installation 2-1
Installing a disk filler module 3-22
Installing a Disk Module 3-20
Installing a disk module 3-20
Installing a New Revision of Licensed Inter-
nal Code 3-12
Installing a VSC 3-31
Installing an SP 3-27
Installing an SP filler board 3-29
Installing or Removing SP Memory Modules
3-23
Installing RAID in a Cabinet 2-1
Installing SP Memory Modules 3-23
Installing the fan module 3-33
Installing the front panel 2-7
Installing the internal disk recorder terminator
2-9
Introduction 1-1
L
Lights
disk module
busy 1-5
fault 1-5
SP
ready 1-4
service 1-4
storage-system power 2-22
Location of memory modules on SP board 3-
24
Location of the customer-replaceable units in
the storage system 1-3, 3-14
Logical unit number 3-7
M
Maximum rebuild time 3-7
Meaning of error message from an SP PROM
update 3-13
Module status, Presentation Utility screen 3-3
Mounting RAID in a Cabinet 2-1
Moving the Grid Cursor 3-4
O
OFF, Disk module status code, Presentation
Utility screen 3-4
Opening and Closing the Fan Module 3-17
Opening the fan module 3-17
Operation Status screen 3-12
Ordering Information
Customer Replaceable Units
Field Replaceable Units B-1
Organization of the Manual 1-1