HEIDENHAIN TNC 335 Technical Manual - Manual (Page 318)

8/95
TNC 360 15 Tool Changer 4-221
15.3.6 Program module MANUAL TOOL OUT
M -> N or M -> S: Normal or Special tool follows Manual tool
The operator is prompted to unload the spindle manually as there is no pocket for the current tool in
the magazine. The called tool is loaded automatically.
OK key
Yes
Prompt user to
unload tool and
press OK key
Load zero in
SPIREG
Move axes to
manual change
position
pressed
TOOL CALL
feedback
M2046 = 1
(spindle empty)
No
Yes
TOOL CALL
strobe set again
GRE1 = P
STANDBY BACK
Module
Yes
Yes
STANDBY
Module
CHANGE
Module
End
No Tool in GRE1
No
Unload GRE1
Fetch tool to
GRE1
No
empty
GRE1 = 0
GRE1