HEIDENHAIN TNC 335 Technical Manual - Manual (Page 485)

7-106
TNC 360 4 PLC Modules 8/95
4.5 Module 9032: Transfer machine parameter values to the PLC
Module 9032 can be used to transfer the value of a machine parameter, designated by its number
and index, to the PLC.
The value of the machine parameter is transferred to the PLC as an integer. The decimal point is
shifted by the number of possible places after the decimal point. An index must always be defined.
For machine parameters without index, enter the value zero.
Module call:
PS K/B/W/D Number of the machine parameter, the value of which is to be read
PS K/B/W/D Machine parameter index
CM 9032
PL B/W/D
Address for machine parameter value
If the machine parameter is read incorrectly, marker M3171 will be set.