7 program module manual tool in/out – HEIDENHAIN TNC 335 Technical Manual User Manual
Page 319
Advertising
4-222
TNC 360
15 Tool Changer
8/95
15.3.7 Program module MANUAL TOOL IN/OUT
M -> M: Manual tool follows Manual tool.
The operator is prompted to unload the spindle and load the new tool manually as there is no pocket
for these tools in the magazine.
OK key
Yes
Move axis to
manual change
position
Prompt user to
unload old and
load new tool
Press OK key
Load T code to
SPIREG
End
pressed
No
Advertising