HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 469)

HEIDENHAIN MANUALplus 620, CNC PILOT 640 469
5.8 Angular measur
ement
WT Compensation number T or G149, first measured edge:
 T : Tool at turret position T to compensate the difference to
the nominal value
 G149 : Additive compensation D9xx to correct the difference to
the nominal value (only possible with compensation type R =1)
FP Maximum permissible compensation
WE Maximum deviation: Probe twice and monitor the dispersion of
the measured values
F Measuring feed rate: Feed rate for probing. If nothing is entered,
the measuring feed rate from the touch probe table is used. If
the entered measuring feed rate F is higher than the one in the
touch probe table, the feed rate is reduced to the value from the
touch probe table.
Q Tool orientation: Orient the touch probe in the programmed
probing direction before each probing operation (machine-
dependent function)
NF Result variable no.: Number of the first global variable in which
the result is saved (no entry = variable 810). The second
measurement result is saved automatically under the next
consecutive number.
P PRINT outputs
 0: OFF: Do not display measuring results
 1: ON: Display measuring results
H INPUT instead of measurement
 0: Default: Obtain measured values by probing
 1: PC test: Simulate probing cycle on the programming station
AN Log no.: Save measurement results in
"TNC:\table\messpro.mep" table (line numbers 0–99; the table
can be expanded if necessary)
Parameters