HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 529)

HEIDENHAIN MANUALplus 620, CNC PILOT 640 529
7.
2 A
u
to
matic w
o
rk
ing plan g
e
ner
a
tion (A
WG)
7.2 Automatic working plan
generation (AWG)
The AWG generates the work blocks of the working plan in the
sequence defined in "Machining sequence." You define the machining
details in the Machining Parameters input form. TURN PLUS
automatically finds all the elements of a work block. Use the
machining sequence editor to specify the machining sequence.
A work block has the following content:
 Tool call
 Cutting values (technology data)
 Approach (may be omitted)
 Machining cycle
 Tool retraction (may be omitted)
 Moving to tool change point (may be omitted)
You can change or supplement the generated work blocks
subsequently.
TURN PLUS simulates the machining in the AWG control graphic. You
can set the sequence and representation of the control graphic via soft
key (see "Graphic simulation" in the User's Manual).
TURN PLUS outputs warnings during the contour analysis
if certain areas cannot be machined at all or not
completely. Check the respective sections after program
creation and adapt them to your needs.