HEIDENHAIN SW 54843x-02 DIN Programming - Manual (Page 51)

HEIDENHAIN MANUALplus 620, CNC PILOT 640 51
1
.4 T
ool pr
ogr
a
mming
1.4 Tool programming
The designations of the tool pockets are fixed by the machine tool
builder. Each tool holder has a unique T number.
In the T command (MACHINING section) you program the T number,
and therefore the position to which the tool carrier rotates. The control
retrieves the assignment of the tools to the turret position from the
turret list of the TURRET section.
You can edit the tool entries individually, or you can call the tool list via
the Set up the turret list menu item and then edit it.
Setting up a tool list
In the "Set up the turret list" function, the control provides the turret
assignment as a tool list for editing.
You have the following options:
 Editing the turret assignment: Transfer tools from the database,
delete entries or move them to other positions (for soft keys see
table).
 Loading the turret list of the Machine mode of operation.
 Deleting the current turret assignment of the NC program.
Loading the turret list of the Machine mode of operation:
 Select "Head > Set up the turret list".
 Switch to "Special functions."
 Load the tool list of the Machine mode of operation
into the NC program.
Deleting a tool list:
 Select "Head > Set up the turret list".
 Switch to "Special functions."
 Delete all entries of the turret list.
Soft keys in turret list
Delete entry
Paste entry from clipboard
Cut out entry and save it in the clipboard
Show entries in the tool database
Save the turret assignment
Close the tool list. You decide whether
the changes made remain in effect
The input window of the selected tool is
opened for editing