HEIDENHAIN MANUALplus 4110 - Manual (Page 394)

394 6 DIN Programming
6.25 D
a
ta Input and D
a
ta Output
WINDOW
Press "Program variable function."
Select "WINDOW" (see figure to the
top right).
„ Select the size of the output window with "lines
for output."
„ Close the output window with "lines for
output = 0."
With the "WINDOW" command, you can define a
specific size for the "output" window that is to be used
for output of information to the machinist. If you do
not program "WINDOW," the control uses an output
window with three lines for the output of information.
The output window is displayed in the lower part of
the "list and program window." It appears on the
screen during the first output of information and is
displayed until you close it or until the interpretation of
the DIN program is concluded.
You can close the output window with a "WINDOW
call" and the parameter value "lines for output = 0."
WINDOW (defining the output window)