HEIDENHAIN MANUALplus 4110 - Manual (Page 465)

HEIDENHAIN MANUALplus 4110 465
9.1 W
o
rk
ing with MANU
ALplus
Finishing cycle 1
The three following finishing cycles finish the contour
area shown in the graphic.
The expanded mode is used for all finishing cycles so
that contour elements such as oblique cuts,
roundings, or chamfers can be machined. In expanded
mode, the tool stops at the end of the cycle. This is
necessary to be able to finish the contour area "in a
single cut."
Finishing cycle 2