HEIDENHAIN TNC 410 - Manual (Page 122)

109 HEIDENHAIN TNC 410
Entering M112 in a positioning block
If you press the soft key M112 in a positioning block (in answer to
the ”Miscellaneous function?” prompt), the TNC then continues
the dialog by asking you for the permissible tolerance T and the
tolerance angle A.
You can also define T and A through Q parameters. See Chapter „10
Programming: Q Parameters“
Effect
M112 is effective during operation with velocity feedforward as
well as with servo lag.
M112 becomes effective at the start of block.
To cancel M112, enter M113.
Resulting NC block
L X+123.723 Y+25.491 R0 F800 M112 T0.01 A10
7.
4 Miscellaneous F
unctions f
or Cont
our
ing Beha
vior