6 sl cycles – HEIDENHAIN TNC 410 User Manual
Page 183
8 Programming: Cycles
170
ú
Setup clearance (incremental value): Distance
between tool tip (at starting position) and workpiece
surface
ú
Milling depth (incremental value): Distance between
workpiece surface and pocket floor
ú
Plunging depth (incremental value):
Infeed per cut. The TNC will go to depth in one
movement if:
■
The plunging depth and the milling depth are equal
■
The plunging depth is greater than the milling depth
The milling depth does not have to be a multiple of
the plunging depth.
ú
Feed rate for plunging: Traversing speed of the tool in
mm/min during penetration
ú
Finishing allowance: Allowance in the machining
plane
ú
Rough-out angle: Direction of the roughing-out
movement The rough-out angle is referenced to the
main axis of the machining plane. Enter the angle so
that the cuts can be as long as possible
ú
Feed rate: Feed rate for milling in mm/min
8.6 SL Cycles
X
Z
Example NC blocks:
8 CYCL DEF 6.0 ROUGH-OUT
9 CYCL DEF 6.1 DIST+2 DEPTH-25
10 CYCL DEF 6.2 PLNGNG+3 F150 ALLOW+0.1
11 CYCL DEF 6.3 ANGLE+0 F350