Setting up the optional speaker bar, Installing the speaker bar, To install the speaker bar – eMachines Flat Panel Monitor User Manual
Page 15: 5 if your computer is not already on, turn it on
www.emachines.com
11
Setting up the optional speaker bar
Installing the speaker bar
To install the speaker bar:
1
Tilt the screen back, then center the speaker bar below the screen. Make sure that the
speakers face forward.
2
Tighten the two thumbscrews on the back of the speaker bar.
3
Connect the speaker bar’s USB power cord to any available USB port on your computer.
4
Connect the speaker bar’s headphone (green) and microphone (pink) cables to your
computer’s headphone and microphone jacks.
5
If your computer is not already on, turn it on.
Tip
When using the optional speaker bar, we recommend that you use the
included right-angle VGA cable for the video connection so the speaker bar does not
obstruct the cable. If you are using a DVI connection, you can order a right-angle DVI
cable from
www.gateway.com
.
Power/Volume control
Power indicator
Kensington lock slot
Headphone jack
Bass port
Bass port
Microphone jack
Headphone jack
8512327.book Page 11 Thursday, May 10, 2007 3:45 PM