eMachines Flat Panel Monitor - Manual (Page 16)

Using Your eMachines Flat-Panel Monitor
12
6 Turn on the speaker bar by rotating the power/volume knob clockwise. The green LED to
the left of the power button is lit when power has been correctly connected and the speaker
bar has been turned on.
Starting the monitor
To start the monitor:
1 Press the power button on the front of monitor. The power LED on the power button turns
blue. If a video signal is not detected for several seconds, the power LED changes from blue
(on) to orange (standby).
2 Turn on your computer. Allow about 10 seconds for the display image to appear. If the power
LED is orange or you do not see a display image, check the connections. For more
troubleshooting information,
see “Troubleshooting” on page 18 .
3 Adjust the tilt of the monitor for the best viewing angle.
4 Use the on-screen display (OSD) to adjust other monitor settings. For more information on
using the OSD and the touch buttons,
see “Adjusting monitor settings” on page 13 .
Power button
8512327.book Page 12 Thursday, May 10, 2007 3:45 PM