eMachines Flat Panel Monitor - Manual (Page 18)

Using Your eMachines Flat-Panel Monitor
14
2 To use an eTouch button, lightly touch it. For adjusting a setting’s values, you can touch and
hold the buttons as you would press and hold conventional buttons.
• Touch (Source) to select the type of input (DVI or VGA) when both DVI and VGA are
connected to your monitor. (When only one video source is connected, you do not need
to select the source.)
• Touch (Auto) to automatically adjust your display image to the ideal settings.
(Available only in VGA mode.)
• Touch (Information) to display current screen resolution and input source.
• Touch (Cancel) to exit the shortcut menu.
• Touch (Main Menu) to open the main menu.
• To turn off the button icons and close the menu, wait about 15 seconds without touching
a button.
Using the main menu
To use the main menu:
1 Touch the (Menu) button on the front of your monitor. The rest of the button icons light
up and the shortcut menu opens.
2 To use a button, lightly touch its icon. For adjusting a setting’s values, you can touch and
hold the buttons as you would press and hold conventional buttons.
3 Touch (Main Menu). The main menu opens.
4 Touch the (Previous and Next) buttons to highlight a setting, then touch (Select) to
open the selected menu or setting. The on-screen button labels change to indicate changed
button functionality. (The following graphic shows typical labels.)
5 Touch the (Increase or Decrease) buttons to adjust the setting or change the option.
Important
The eTouch menu buttons are very sensitive, and may be “pressed” by holding
your finger just above its surface. To completely “release” a touch button, make sure
that you lift your finger well away from the button.
Tip
Button labels on the eMenu screens align with the eTouch buttons on the front
of the monitor.
Previous
Select
Back (availability depends
on the current menu)
Next
Menu Off
8512327.book Page 14 Thursday, May 10, 2007 3:45 PM