JBL Synthesis SDA 4600 User Manual
Page 6
6 |
J B L S y n t h e s i s S D A 8 3 0 0 / S D A 4 6 0 0 S y s t e m G u i d e
SDA8300 (SINGLE)
BI-AMP crossover settings are controlled from the SDEC4500P and must be
configured with either “JBL Synthesis ARCOS” software or “SDEC Control Panel
Software v1.5”. Go to
to download the correct software
SDA8300 (SINGLE)
CONFIGURATION 1
AMP CHANNEL
LEFT
1
RIGHT
2
CENTER FULL RANGE / CENTER LOW
3
CENTER HIGH (Bi-Amp Only)
4
SIDE LEFT
5
SIDE RIGHT
6
REAR LEFT
7
REAR RIGHT
8
Factory Default Configuration 1
Nothing should be done to the amplifier. It is factory set to this
configuration. DO NOT INSTALL ANYTHING INTO THE GPIO INPUT. If you
accidentally insert the Configuration Trigger and need to reset the unit,
contact Technical Support for Step by Step Instructions,
or toll free at +1 (888) 691-4171.
Step Four – Configuration and Identification
SINGLE SDA8300
Configuration 1 is the default factory settings for use with a single SDA8300.
This is configuration 1. If you are using these factory default outputs no
configuration is needed, and doing so will cause the units to operate
incorrectly. If you accidentally select one of the alternate configurations
below you will need to contact JBL Synthesis Technical Support to reset the
unit.
Use with these systems:
•
Any standard system with no more than 7 main speakers
•
Any system with an active or passive Bi-amplified Center Only
•
Synthesis-Four
•
Synthesis-Three-Array
•
Synthesis-Two
•
Synthesis-Atlas (7.1)
•
Synthesis-K2 with SK2-3300 Center Channel (Bi-Amp Center)
•
Synthesis-Everest with SK2-3300 Center Channel (Bi-Amp Center)
4