JBL Synthesis SDA 4600 - Manual (Page 7)

7 | J B L S y n t h e s i s S D A 8 3 0 0 / S D A 4 6 0 0 S y s t e m G u i d e
SDA8300 (Dual – Amp #1)
SDA8300 (Dual – Amp #2)
SDA8300 (DUAL)
CONFIGURATION 2 AMP CHANNEL
LEFT FULL RANGE / LEFT LOW 1
LEFT HIGH 2
RIGHT FULL RANGE / RIGHT LOW 3
RIGHT HIGH 4
CENTER FULL RANGE / CENTER LOW 5
CENTER HIGH 6
AUX 1 LEFT / HEIGHT LEFT FRONT 7
AUX 1 LEFT / HEIGHT RIGHT FRONT 8
CONFIGURATION 3 AMP CHANNEL
SIDE LEFT 1 1
SIDE RIGHT 1 2
SIDE LEFT 2 3
SIDE RIGHT 2 4
SIDE LEFT 3 / HEIGHT LEFT REAR 5
SIDE RIGHT 3 / HEIGHT RIGHT REAR 6
REAR LEFT 7
REAR RIGHT 8
Configuration 3
Configuration 3 is selected by inserting the RJ25 plug with the label
“CONFIGURATION 3” into the rear panel “GPIO”.
Configuration 2
Configuration 2 is selected by inserting the RJ25 plug with the label
“CONFIGURATION 2” into the rear panel “GPIO”.
Step Four (Continued) – Configuration and
Identification DUAL SDA8300
Configuration 2 + Configuration 3 is used with these expanded systems or
where additional bi-amp or height/aux channels are needed.
Use with these systems:
• Any 9 or 11 channel system
• Any system that requires height channels (4 supported)
• Any system with active or passive Bi-amplified L+R and/or Center
• Synthesis-One-Array
• Synthesis-K2 (Bi-Wire or Bi-Amp)
• Synthesis-Everest (Bi-Wire or Bi-Amp)
4 Co
n
fig
u
ratio
n
2
Co
n
fig
u
ratio
n
3