EverFocus DVR EDR810M - Manual (Page 31)

 Installing the Camera(s) and Monitor
The DVR is typically connected to one camera installed inside the car. Other camera(s) can also
be installed in different locations (for example, use the waterproof camera to the outside of
vehicle). For installation procedure, please refer to the guide that came with the camera(s) you
purchased.
The Monitor power supply connects from the Automotive adapter (cigarette plug)
Monitor and cameras must be purchased separately.
 Connect the Camera(s)Connect the power connector from the camera(s) harness into the
CAMERA POWER OUT jack on the back panel of the DVR.
Connect the primary camera(s) video connector to the CAMERA INPUT and the audio connector
to the AUDIO INPUT in the back panel.
Adjust the camera(s). After the camera is installed, connect a monitor directly to the camera and
observe the image.
Make any adjustment if necessary.
LCD Monitor
LCD Monitor