Epson BALUNS FG01281 - Manual (Page 18)

18 Setting Up the Document Camera
Connecting the S-Video Cable
Before you start, make sure your document camera and projector or
TV are turned off.
1. Connect one end of the S-video cable to the document camera’s
S-VIDEO OUTPUT port.
2. Connect the other end to the S-video input port on the projector
or TV.
Connecting to a Computer
The document camera comes with two RGB video input ports. These
can be used to connect up to two laptops or desktop computers to the
document camera.
This is especially useful if your projector has only one input port. You
can connect one or two computers to the document camera’s RGB
input port(s) as described below, and connect the document camera to
the projector’s input port as described on page 16. This way, you can
use the camera’s remote control to switch between picture sources.
Follow the instructions on page 24 to switch between the sources.
or
Projector
TV S-VIDEO OUTPUT port
note
For best image quality when
projecting a computer image,
connect your projector or
monitor to the document
camera using the RGB OUT
port.