Magnum Energy AGS Stand Alone (ME-AGS-S) - Manual (Page 31)

© 2013 Magnum Energy, Inc. 28
Appendix
A-1 Appendix
Optional Accessories for the ME-AGS-S
The following two Pigtail Adapters are available from Magnum Energy for
use with the ME-AGS-S. They are useful in applications where there is a
requirement to conveniently and automatically turn the generator on/off
externally through a manually controlled switch or from an automatically
controlled switching device (i.e., use air conditioner thermostat controls to
turn gen on to run air conditioner):
The ME-PT1 (Pigtail One-wire) adapter is designed to allow the AGS to start
the connected generator when an external +12 volt DC supply is applied.
The ME-PT2 (Pigtail Two-wire) adapter is designed to allow the AGS to start
the connected generator by an external two-contact switch.
Additional Magnum Equipment/Accessories
The following components are also available from Magnum Energy:
MS Series Inverter/Chargers
The MS Series inverter/charger is a pure sine wave inverter designed
specifi cally for mobile and off-grid applications. The MS Series has a built-in
PFC (Power Factor Corrected) charger that uses 25-30% less AC current than
standard chargers. The MS Series also provides multiple ports, including an
RS485 communication port for network expansion, and a remote port.
MMP Series Enclosures
The MMP175-30D, MMP175-60S, MMP250-30D, and MMP250-60S enclosures
are specifi cally designed for single inverter applications. The MMP Series en-
closures combine all of the major components required for a renewable energy
system—inverter/battery disconnect, AC overcurrent protection, grounding
connections, and a full system inverter bypass—into a single, easy to install
pre-wired enclosure.
Advanced Remote Control Display
The ME-ARC allows advanced features of the Magnum inverter or accessory to
be confi gured. This LCD remote display includes a FAVS button to access your
favorite features quickly and provides advanced monitoring/troubleshooting.
Basic Remote Control Display
The ME-RC remote control is simple to use; an easy-to-read LCD screen
and “at a glance” LEDs display complete inverter/charger status. Soft keys
provide simple access to menus and a rotary encoder knob allows you to
scroll through and select a wide range of settings such as INVERTER ON/OFF,
CHARGER ON/OFF, SHORE power breaker setting, AGS control, and METER,
SETUP, and TECH menus.
Battery Monitor
The Battery Monitor Kit (ME-BMK) is a single battery bank amp-hour meter
that monitors the condition of the battery and provides information to let
you know how much energy you have available. It also lets you plan your
electrical usage to ensure the battery is not being over-discharged.
Fuse Block/Fuses
The Magnum fuse/fuse-blocks are used to protect the battery bank, inverter,
and cables from damage caused by DC short circuits and overloads. They
include a slow-blow fuse with mounting block and protective cover. The 125
and 200-amp models use an ANL type fuse and the 300 and 400-amp models
use a Class-T fuse.