Epson Expression 1680 - Manual (Page 104)

Using Optional Equipment
97
Removing the Shipping Screw
To prevent damage during shipping, a shipping screw is attached to the transparency
unit to secure its lamp assembly. You must remove this screw before using the
transparency unit.
1. Turn the transparency unit so the glass side faces up.
2. Use a Phillips head (cross
head) screwdriver to remove
the shipping screw from the
hole labeled
CLAMP , as
shown at right.
3. Install the screw in the
storage hole labeled
STOCK .
Before transporting the scanner, remove the transparency unit, reinstall the shipping
screw in the hole labeled
CLAMP , and slide the transportation lock on the back of the
scanner to the LOCK position. See “Transporting the Scanner” on page 111 for
instructions.
Installing the Transparency Unit
Follow these steps to install the transparency unit on the scanner.
1. Make sure the scanner is turned off. Then unplug the power cable from the
scanner.
2. Remove the document
cover by grasping the back
of the document cover and
easing the cover up.
3. Make sure the document
table is clean and dust free.
1680.book Page 97 Thursday, March 1, 2001 4:28 PM