Epson Expression 1680 - Manual (Page 128)

Solving Problems
121
Windows NT, check the SCSI
Adapters dialog in the Windows
Control Panel.
■ For SCSI connections, check for
conflicts in your SCSI ID
setting, I/O address, the
interrupt setting for your SCSI
board, and other settings. For
information about the SCSI ID
setting, see “Connecting to a
SCSI Interface” on page 19. For
information about choosing
other settings, see your
computer manual.
■ If you have more than one
scanner connected to your
computer, make sure the
Expression 1680 is selected as
your default scanner. For
Macintosh, check the
EPSON Scanner Selector. For
Windows Me, Windows 2000,
or Windows 98, check the
Utility tab on the Expression
1680 Properties window. For
Windows 95 or NT, check the
EPSON TWAIN Pro window.
■ Make sure you selected EPSON
TWAIN Pro as your TWAIN
source.
■ If you have an older EPSON
scanner and have a previous
version of EPSON TWAIN
installed, uninstall the older
version (Windows) or close any
extensions like EPSON
Scanner Monitor , EPSON
Scanner Monitor USB , or
EPSON Monitor 3
(Macintosh).
■ If none of these solutions help,
uninstall your software, then
reinstall it. See the instructions
for uninstalling software
beginning on page 127.
You can’t start EPSON TWAIN
Pro Network from a client
computer.
■ Make sure the scanner and
the scanner server are both
powered on, and that the Scan
Server is running on the server.
■ Make sure the cables connecting
the scanner, the scanner server,
and the client computer meet
system requirements and are
properly connected.
■ Make sure the correct IP address
for the scanner server is entered
in the EPSON TWAIN Pro
Network setup window for the
client computer.
■ Make sure the network interface
card is installed correctly in
both the scanner server and the
client computer.
1680.book Page 121 Thursday, March 1, 2001 4:28 PM