Edimax Technology EDIMAX FAST ETHERNET MFP SERVER VERSION: 2.0 - Manual (Page 103)

97
13.2.1 Enable MFP Server’s TCP/IP Support
The default configuration of the MFP Server is with TCP/IP support enabled.
You can configure the MFP Server to enable TCP/IP support using the
configuration program.
13.2.2 Setup MFP Server’s IP Address
The MFP Server must have a unique IP address in order to be recognized by
the network.
You can set up the IP address on the various Unix/Linux systems using any
one of the following methods:
1. DHCP (Dynamic Host Configuration Protocol)
2. BOOTP (Bootstrap Protocol)
The MFP Server will use these two methods to obtain IP address
automatically if its IP address is configured as Auto (0.0.0.0).
13.2.2.1 DHCP
There are many Unix/Linux systems that support DHCP protocol, and the
procedures to configure the DHCP server database are different. Please refer
to the manual of Unix/Linux for the way to use different DHCP Server. It is
highly recommended that the DHCP server should be located on the same
network as the MFP Server.