Edimax Technology EDIMAX FAST ETHERNET MFP SERVER VERSION: 2.0 - Manual (Page 90)

84
11. The MFP Server will try to determine your network settings. If a DHCP
Server is present, the MFP Server will automatically obtain the network
settings assigned by the DHCP Server. If no DHCP Server is present,
please assign the network settings of the MFP Server manually. By default,
the network settings of the MFP Server in “Manual IP” selection are as
below.
IP Address: 192.168.2.2
Subnet Mask: 255.255.255.0
Please click “Next” once you have found appropriate network settings for
the MFP Server.
Note: The MFP Server IP Address should be in the same network segment
with the networking computers. If the network settings are incorrect, a
message will be prompted to remind you after you click “Next”. Please
make sure that you have set the right settings before going to the next step.
If you don’t want to set it now, please click “Cancel” to finish the installation.
You can then use the “Server Manager” utility to configure the MFP Server.