Edimax Technology EDIMAX FAST ETHERNET MFP SERVER VERSION: 2.0 - Manual (Page 19)

13
12. Please set the network settings for the MFP Server manually. By default,
the network settings are as follows.
IP Address: 192.168.2.2
Subnet Mask: 255.255.255.0
If you select “DHCP”, the MFP Server will try to determine your network
settings automatically. If a DHCP Server is present within the network, the
MFP Server will automatically obtain and configure the network settings
from the DHCP Server. The assigned IP Address will be shown in the IP
Address fields. If no DHCP Server is present within the network, please
assign the network settings of the MFP Server manually. Please click
“Next” once you have found appropriate network settings for the MFP
Server.
Note: The MFP Server IP Address should be in the same network
segment with the connected computer. If the network settings are incorrect,
a message will be prompted to remind you after you click “Next”. Please
make sure that you have set the right settings before going to the next step.
If you don’t want to set it now, please click “Cancel” to finish the installation.
You can then use the “Server Manager” utility to configure the MFP
Server.