CarAlarms.com P90-NG1 - Manual (Page 37)

Excalibur ® P90 Zero Clearance Direct Vent Gas Fireplace 37
Door
Flange
OPTIONAL
SCREEN DOOR
1) Attach door bracket to side using 2
screws.
GLASS DOOR
INSTALLATION
1) Fit top door bracket over the fl ange at the
top of the fi rebox.
2) Secure with 2 screws on the bottom.
Single Screen Door - only attach to right
side of unit.
Double Screen Door - attach to left and right
side of unit.
2) Slide the door(s) onto the hinges.
3) Single Screen Door only: Push the Locking
Ball Pin into the hole on the left side. Squeeze
the clamp (use pliers) and slide it over the
end of the Locking Ball Pin and tight against
the Facade edge.
Door Bracket
attaches with
2 screws.
ARCH SURROUND
1) Place the Arch Surround into position by
sliding the 2 holes in the bottom brackets
over the pins on the base.
2) Slide the 2 screws on the rear of the Arch
Surround into the bracket on the Glass Door
and then tighten screw to secure.
Fit the bottom brackets over
the pins on the base.
View from underneath of the
screw and the bracket.
Screw
Bracket
Tighten both screws to secure Arch Surround
to Glass Door.
3) Slide Bottom Louver into position. On each
side secure the bottom screw fi rst into the
side bracket. Do not overtighten, leave
slightly loose to allow the louver to move
freely. Then tighten the top screw.
4) Attach the two control boxes to the bottom
unit base and tighten the 2 screws on the
left side and 1 screw on the right side.
Bottom
Screw
Top
Screw
Secure left side with 2 screws and right side
with one screw.
INSTALLATION