CarAlarms.com P90-NG1 - Manual (Page 38)

Excalibur ® P90 Zero Clearance Direct Vent Gas Fireplace 38
ACCENT KIT INSTALLATION
2) Take the hoseclamps and put them over the back of each rivet. Squeeze
the hoseclamp to secure onto rivets ensuring that the hoseclamp is
touching the back side of the surround. The hoseclamp can now be
released.
3) Remove the handles by removing the nut and screw. Install the new
handles by placing them in position over the holes on the surround
louver. Put the screws through the holes and secure them by tightening
them with a nut.
4) Place the emblem over the emblem design on the surround. Insert
the studs through the holes. To secure them fi rst put on the split lock
washer and then the nut and tighten.
5) Remove the 2 studs on the sides of the Hood. Insert the new studs
through the holes and secure them by fi rst putting on the washer and
then tighten with a nut.
DOUBLE & SINGLE DOOR OPTION
1) Remove the handles by removing the nut and screw. Install the new
handles by placing them in position over the holes on the door(s).
Put the studs through the holes and secure them by tightening them
with a nut.
1) Remove the rivets from the surround by pulling out the hoseclamp with
a screwdriver or plyer. Re-install the rivets by putting them through
the holes on the sides of the surround.
INSTALLATION