Emerson 1F92 User Manual

Page 15

Advertising

Installation

INSTALLER CONFIGURATION

BEFORE TURNING POWER
ON, please read the following
instructions. Before operating the
system, you must configure the
thermostat to operate properly
with your equipment.

The thermostat, as it comes from the
factory, is configured to operate a
standard multi-stage electric
forced hot air system with a single
stage air conditioning compressor
and fan. In this configuration, the
thermostat will turn on the fan
immediately on a call for heat. If
you are unsure whether your system
requires the thermostat to control
the fan, contact your furnace/air
conditioning system manufacturer or
a qualified heating/air conditioning
service person.

Your new thermostat has an Installer
menu, which allows you to custom-
ize the thermostat to meet your
requirements.

(The thermostat also has a User
menu and a Keypad Lockout
menu; these menus are explained
further in the CONFIGURATION
section.)

The menu settings can be changed at
any time to meet system or personal
requirements.

ENTERING THE

ENTERING THE
CONFIGURATION MENUS

CONFIGURATION MENUS

After properly wiring the thermo-
stat, turn on power to the system.
Momentarily press PROGRAM

RUN

to make certain the thermo-

stat is in the run program mode,

then press TIME

FWD

and TIME

BACK

at the same time to enter the

User Configuration menu. When the
display changes to the first item in
the configuration menu, release the
buttons. Then press and hold SET

TIME

and SET

DAY

for approxi-

mately 3 seconds to enter the
Installer menu. The display will
change to show the first item on the
Installer menu (multi-stage/heat
pump selection). Use the following
text, along with the Installer table
on page 16, to guide you through
the menu.

Once in the menu, you set each item
to the proper selection using
or

, then press TIME

FWD

change the display to the next item
or TIME

BACK

to return to the

previous item.

Advertising

Popular Brands

Popular manuals