Emerson 1F92 - Manual (Page 25)

23
The configuration menus allow you
to set certain thermostat operating
characteristics to your system or
personal requirements.
To enter the User Configuration menu,
press PROGRAM
RUN to make sure
the thermostat is in the run program
mode, then press TIME
FWD and
TIME BACK at the same time. The
display will show the first item in the
configuration menu.
The following charts (pages 24 & 25)
describe each item on the menus. Press
TIME
FWD to move forward to the
next item in the menu or TIME BACK
to move backward to the previous item.
Set these according to your personal
preference using
or . To
enter the Keypad Lock menu, while in
the User Menu, press and hold TIME
FWD and TIME BACK for at least
two seconds.
To exit either menu and return to normal
operation, press PROGRAM
RUN . To
re-enter to the User menu at any time
press PROGRAM
RUN , then press
TIME FWD and TIME BACK at the
same time. While in the menus, if you
do not press any buttons for two
minutes, the thermostat will revert to
normal operation.
CONFIGURATION
Configuration