Emerson 1F92 - Manual (Page 9)

7
Installation
Insert the wires into the terminals on
the base using the appropriate
wiring diagram and tighten the
terminal screws.
CONFIGURING CONFIGURING CONFIGURING CONFIGURING CONFIGURING
AND PROGRAMMING
AND PROGRAMMING AND PROGRAMMING AND PROGRAMMING AND PROGRAMMING
Before the power is turned on, the
thermostat must be configured to
operate properly with the system.
See the CONFIGURATION section
of this manual.
This thermostat can be programmed
for automatic temperature control.
Refer to Operating Instructions for
programming.
Figure 1. Thermostat base and terminals Figure 1. Thermostat base and terminals Figure 1. Thermostat base and terminals Figure 1. Thermostat base and terminals Figure 1. Thermostat base and terminals
1 Mounting screws
2 Pull wires through this opening
3 Insert wires into terminal holes, then tighten screws
4 Screw anchors
R C E W2 W1 Y2 Y1 B O G
PH D SA SB SC OT L
1
2 3
4
1
W3
A1
E2
P