Emerson WORLD CLASS 3000 - Manual (Page 9)

Instruction Bulletin
106-300NE Rev. 3.4
May 2000
Rosemount Analytical Inc. A Division of Emerson Process Management Description 1-1
World Class 3000
SECTION 1
DESCRIPTION
1-1 COMPONENT CHECKLIST OF TYPICAL
SYSTEM (PACKAGE CONTENTS)
A typical Rosemount World Class 3000 Oxygen
Analyzer with HPS 3000 Heater Power Supply
package should contain the items shown in
Figure 1-1. Record the Part Number, Serial
Number, and Order Number for each
component of your system in the table located
on the first page of this manual.
1-2 OVERVIEW
a. Scope
This Instruction Bulletin has been designed
to supply details needed to install, start up,
and troubleshoot the Rosemount World
Class 3000 Oxygen Analyzer with HPS
3000 Heater Power Supply Field Module.
The Heater Power Supply allows the
World Class 3000 Oxygen Analyzer (Probe)
to be interfaced to a number of different and
earlier model electronic packages. These
electronic packages are not covered in this
manual. For specific information concerning
calibration and operation of the system,
refer to the Instruction Bulletin applicable to
your electronics package.
b. System Description
The Rosemount Oxygen Analyzer (Probe) is
designed to measure the net concentration
of oxygen in an industrial process; i.e., the
oxygen remaining after all fuels have been
oxidized. The probe is permanently posi-
tioned within an exhaust duct or stack and
performs its task without the use of a sam-
pling system.
4
3
2
1
19260001
Figure 1-1. Typical System Package
1. Oxygen Analyzer (Probe)
2. Heater Power Supply
3. Instruction Bulletin
4. Mounting Adaptor Plate
with Mounting Hardware
and Gasket
1