Edirol R-4 - Manual (Page 13)

13
Introducing the R-4
fig.panel-2.eps_50
Display
This shows various information about the R-4’s status.
For details, refer to
“Display” (p. 18).
PREV button [PREV]
Pressing the PREV button while a project is playing or stopped will take you to the beginning of the project
(00:00:00). Pressing this button at the beginning of a project will take you to the preceding project.
You can also press and hold down this button to rewind. This is available both while playing and while
stopped.
* If the system setting Player Setup parameter Play Mode is set to Single , you can't move to the previous or next
project during playback.
NEXT button [NEXT]
Pressing the NEXT button will take you to the next project. You can also press and hold this button to fast-
forward. This is available both while playing and while stopped.
* If the system setting Player Setup parameter Play Mode is set to Single , you can't move to the previous or next
project during playback.
Stop button [STOP]
This button stops playback or recording. If you press the STOP button during playback, the counter will
maintain the time at which you pressed the STOP button .
Pause button [PAUSE]
This button pauses playback or recording.
Play button [PLAY]
This button starts playback. The PLAY button is lit blue during playback.
During playback, you can press the PLAY button once again to play at double-speed. During double-
speed playback, press the PLAY button once again to return to normal playback. During double-speed
playback, the lower part of the display will indicate PLAY X2 . Double-speed playback will change the
pitch.
* If you want to turn off the double-speed playback feature, go to the System Settings menu and in Player Setup ,
turn X2 Play OFF . For details, refer to “2 Player Setup” (p. 62).
Record button [REC]
Recording will begin immediately when you press the REC button . The REC button is lit red during
recording. If you hold down the PAUSE button and press the REC button , the REC button will blink
red, and the R-4 enters recording-standby mode. Recording will begin when you then press the REC
button or PAUSE button .
Input level knobs 1–4 [INPUT GAIN]
These knobs adjust the input level of combo input jacks 1–4 ( ). Input levels of the internal mics
( ) are adjusted by knob 1 (MIC-L) and knob 2 (MIC-R).
Monitor level knob [MONITOR]
This adjusts the output volume of the internal speakers ( ) and the headphone jack ( ).
You can’t adjust the volume of the line output jacks ( ). If you need to adjust the volume of the line
output jacks, adjust the controls of the external speakers or playback system connected to the line output
jacks.
Front panel
18 19 20 21 22 23
25 26
24
18
19
20
21
22
23
24
22
25
39
1
26
2 37
40
R-4_e.book 13 ページ ２００５年２月１０日 木曜日 午後３時３６分