Edirol R-4 - Manual (Page 79)

79
Messages
This section explains the most important messages that may appear in the R-4’s display
Message Status
Int-Batt Low!
The internal battery has run low.
The internal battery must be replaced. If it runs low, the internal clock
will become inaccurate. Please contact one of the service locations list-
ed on the warranty card to have the battery replaced.
Battery Low!
The batteries have run low.
Install fresh batteries, or use the AC adaptor.
HDD Slow!
Data could not be written to the hard disk fast enough. This message
may be encountered after you’ve repeatedly written and erased
project files, and have thus caused the files on the hard disk to become
fragmented, slowing down the access speed.
Media Full!
There is insufficient free space on the hard disk or CompactFlash
card.
Transfer project files to your computer to free up more space.
Over 2GB
The project is too large.
This message will appear if the project newly created by appending
an existing project exceeds 2 GB.
The R-4 can handle files up to 2 GB in size.
Project exists!
An identically named project already exists.
Create the project using a different name.
File-Sys Error!
A problem has occurred with the file system.
Name too long!
The project name is too long.
This message will appear if the project name newly created when you
use Trim, Combine, or copy a project is too long.
You’ll need to shorten the name of the source project.
Improper Proj.
The R-4 cannot handle this project.
HOLD ON
The HOLD switch is on.
This message will appear if you attempt to operate the R-4 while the
HOLD switch is on.
Now Recording
The R-4 is recording now.
This message will appear if you attempt to operate the R-4 during re-
cording. If you need to perform an operation, you must first stop re-
cording.
Now Playing
The R-4 is playing now.
This message will appear if you attempt to operate the R-4 during
playback. If you need to perform an operation, you must first stop re-
cording.
LANC Offline
The connection with the L connector has been broken.
This message will appear if signals from the L connector are inter-
rupted, or if the cable is disconnected.
R-4_e.book 79 ページ ２００５年２月１０日 木曜日 午後３時３６分