Enterasys Networks C1H124-24 - Manual (Page 41)

Connecting to the Network
Hardware Installation 3-13
To connect an MT-RJ cable to a fixed MT-RJ connector of a Mini-GBIC, refer to Figure 3-12 and
proceed as follows:
1. Remove the protective covers (not shown) from the front panel MT-RJ fiber-optic port (port
52 in this example) and from the connectors on each end of the cable.
2. Insert the MT-RJ cable connector into the MT-RJ connector until it clicks into place.
Figure 3-12 Cable Connection to MT-RJ Multimode Fiber-optic Connectors
NOTE: Leave the protective covers in place when the connectors are not in use to
prevent contamination.
CAUTION: Do not touch the ends of the fiber-optic strands, and do not let the ends
come in contact with dust, dirt, or other contaminants. Contamination of cable ends
causes problems in data transmissions. If the ends of the fiber-optic strands become
contaminated, use a canned duster to blow the surfaces clean. A fiber-port cleaning
swab saturated with optical-grade isopropyl alcohol may also be used to clean the ends.
NOTE: To remove the MT-RJ cable connector , press on its release tab and pull
out the cable connector.
Mini-GBIC MT-RJ port connector shown on C1H124-48 Release tab
MT-RJ cable connector Link/Activity LED
Б
А
3831_02_08
CPU RPS 1 49
51
2 50 52
1
2 52
50
49
51
В
Г