Enterasys Networks C1H124-24 - Manual (Page 46)

Connecting to Console Port for Local Management
3-18 Hardware Installation
4. Turn on the PC and configure your VT emulation package with the following parameters:
When these parameters are set, the Startup screen will display. Proceed to Section 3.7 to complete
the installation.
Figure 3-14 Connecting an IBM PC or Compatible
3.6.3 Connecting to a VT Series Terminal
To connect a VT Series terminal to an Enterasys Networks device Console port ( Figure 3-15 ), use
a UTP straight-through cable with RJ45 connectors and an optional RJ45-to-DB25 female
adapter, and proceed as follows:
1. Connect the RJ45 connector at one end of the cable to the Console port on the Enterasys
Networks device.
2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB25 female
adapter .
3. Plug the RJ45-to-DB25 adapter to the port labeled COMM on the VT terminal .
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit
UTP straight-through cable with RJ45 connectors RJ45-to-DB9 PC adapter
RJ45 Console port shown on C1H124-48 PC
Г
Б
В
А
3831_01_09
CPU RPS 1 49
51
2 50 52
1
2 52
50
49
51