Everpure 327 - Manual (Page 73)

Cold Drink Center (327/328) Operator’s Guide
3280020 Page 67 August, 2003
6. Dump the ice and place the pail back in its original position underneath the
cup station. It is recommended that you dump the ice so that the pail will not
fill during the Coolsan process.
7. For convenience, the machine will wait one minute after the ice is dumped to
allow the operator to move the pail under the cup station. The display will
read "
MOVE PAIL " with the time message transposed.
8. Once the one minute delay expires, the hopper will drain and the feeder cup
will be prepared for adding solution. This operation will last about 2 minutes.
9. Once the feeder cup is prepared, the display will read " ADD SOLUT'N ". At this
time the operator will have one minute to add the Coolsan solution.
10. From this point, the machine will run the rest of the coolsan process
automatically and no operator interaction will be required.
11. The ice maker will be washed and drained. This operation will last about 11
minutes. After the ice maker is washed and drained, the ice maker will be
rinsed. Rinsing will take about 17 minutes.
12. The last Coolsan operation will clean out the water system. This will take
about 4 minutes.
13. At the end of the process the display will show "
FINISHED
" for 10 seconds and
beep 3 times. After 10 seconds, the display will return to the "COOLSAN" list
item.
ADDITIONAL NOTES:
• If power is interrupted during the Coolsan process, the process will auto-
matically continue once power is restored.
• The pail may fill during the coolsan process if the ice is not dumped from
the ice maker when the pail is replaced. If the pail is full, the process will
stop and "
PAIL FULL
" will display. To continue the Coolsan process, remove
the pail and dump its contents. The display will show " PRESS START KEY TO
CONTNUE " in a flashing sequence. Replace the pail under the cup station and
press the key and the Coolsan process will continue.
14. CONTINUE.