Edirol R-09HR - Manual (Page 92)

92
R-09HR configuration settings
Selects the reverb type.
fig.plaersetting-e.eps_80
1.
Select “Player Setup” from the <Menu
Screen>.
Use the [PLAY Button ] and [STOP Button ] to select
“Player Setup,” then press the [REC Button].
fig.plaersetting-e.eps_80
2.
Select “Rev Type.”
Use the [PLAY Button ] and [STOP Button ] to move
the cursor to the Rev Type line.
fig.plaersetting-e.eps_80
3.
Set the reverb type.
Use the [PREV button ] and [NEXT button ] to change
the Rev Type value.
• When finished with the settings, press the [MENU button] to return to the previous screens, in order.
• The reverb type can also be switched in the main screen. Press the [REVERB Button] for a number of
seconds in the main screen to display the reverb on/off screen. While this screen is displayed,
change the reverb type by pressing the [PREV button
] or [NEXT button ].
• Reverb cannot be be applied when playing a song with a sampling frequency of 88.2 kHz or 96 kHz.
Setting the reverb type (Rev Type)
Type Effect
HALL1 This reverb effect simulates the reverberation in a
concert hall. A mild reverberation with a long,
spreading sound is obtained. Hall 2 has shorter
reverberation than Hall 1.
HALL2
ROOM
This reverb effect simulates the reverberation in a
room. A short, bright reverberation that simulates a
live stage is obtained.
PLATE
This reverb effect simulates plate reverberation (a
reverberation unit using vibrations from metal
plates).
A metallic-sounding reverberation with an extended
high range is obtained.
Move the
cursor
up or down
Enter
Move the
cursor
up or down
Change
the value
R-09HR_e.book 92 ページ ２００７年１２月１７日 月曜日 午後２時１６分